The tension zone is both beautiful and comfortable. After replacing the sheets, you don’t have to worry about the sheets wrinkles and deformation, very practical.
We will sew in a natural fabric: 100% cotton satin lines. To this end, we need: cloth, linen, scissors, pin, line, chalk and tape measure.
We have made the following parameters on the mattress: 120 cm long, 60 cm wide, 15 cm high of the mattress.
Cut a rectangle, one side is 120 cm (mattress length) + 30 cm (mattress height 15 cm * 2) + 16 cm (sheets will be 8 cm under the mattress, 8 cm * 2) + 6 cm (bend) 3 cm * 2)) = 172 cm
The other side of the rectangle is 60 cm (mattresses width) + 30 cm (mattress height 15 cm * 2) + 16 cm (bedtap 8 cm below the mattress, 8 cm * 2) + 6 cm (3 cm * 2 Next) = 112 cm.
Now it is now folded into two halves, and the face is facing. Now, the generated rectangle, you need to fold it half. The result is a rectangle folding 4 times. Look carefully to all edges and corners very smooth.
On the long side of the rectangle folded from the fabric, we leave half of the length of the mattress 120/2 = 60 cm and mark it.
On the short side of the rectangle, we measures half of the 50/2 = 50 cm from the fabric and marked from the fabric.
From the received labeled to the edge (incision), it should be kept at 26 cm (15 cm mattress height + 8 cm) for the edge of the mattress + 3 cm below the mattress).
We draw a square with a side length of 26 cm, from the obtained line to the edge to reserve 1.5 cm and draw lines.
Cut the square, this is what we get.
We fold each part of the angle from the inside, smooth and neatly aligned.
We use linear stitches 0.7 cm from the edge of the margin.
Ironing.
Next, the fabric faces folded, draws the direct seam, ironing.
The line is laid on the position of 0.8 cm from the edge and peeled off again.
Ironing seam on one side, transfer, the front effect is as follows